Sunroof Lid Seal – 2005-2008 Nissan

NTB06-066b

 

PATHFINDER, FRONTIER, MURANO, ALTIMA SEDAN, AND ALTIMA COUPE; SUNROOF LID SEAL

 

APPLIED VEHICLES:

2005 – 2008 Pathfinder (R51)
2005 – 2008 Frontier (D40) Crew Cab
2005 – 2007 Murano (Z50)
2007 – 2008 Altima Sedan (L32)
2008 Altima Coupe (CL32)

 

IF YOU CONFIRM

The sunroof lid seal is not sealing correctly.

 

ACTIONS

1. Make sure the sunroof glass rubber edge is in good condition.
2. If the rubber edge is in good condition, replace the sunroof lid seal with the new one listed in Parts Information.

 

PARTS INFORMATION

DESCRIPTION	MODEL	PART #	QUANTITY
Sunroof Lid Seal	R51 & D40	91245-EA50A	1
Sunroof Lid Seal	Z50 & L32	91246-9W01A	1
Sunroof Lid Seal	CL32	91246-JB11A	1

 

SERVICE PROCEDURE

1. Remove the sunroof lid assembly.
   • Refer to section RF in the Service Manual.
2. Check the sunroof glass rubber edge (see Figure 1).

Figure 1

 

• If the rubber edge is deformed or damaged (see Figure 1 for example), this bulletin does not apply. The entire sunroof lid assembly must be replaced.
• If the rubber edge is in good condition, continue with this procedure.

3. Remove the old sunroof lid seal.
   • Just pull it off.

Figure 2

 

4. Install the new seal.
   • Stretch the seal around the sunroof lid.
   • Push the seal into the “ditch” (channel).
   • Make sure the seal is pushed all the way into the ditch—no lifted areas.

Figure 3

 

NOTE:  If needed, very light taps with a rubber hammer can be used to press the seal into the “ditch”.

5. Reinstall the sunroof lid into the vehicle. Make sure the sunroof operates correctly and seals correctly.